Oki C5400 reset

Re-setting the drum, belt and toners for Oki C5400.

  1. Power on printer while holding both the "+" & "-" buttons simultaneously; release when “OKIUSER” is displayed.
  2. Press either the "+" or "–" button until “ENGINE DIAG MODE” is displayed; press "Enter" and “DIAGNOSTIC MODE xx.xx.xx” will be displayed.
  3. Press and hold both the "-" & "On-line" buttons simultaneously until “ENG DIAG LEVEL2” is displayed.
  4. Press either the "+" or "–" button until “CONSUMABLE COUNTER SET” is displayed, press "Enter" to go in the menu to set various consumables.
  5. Press either the "+" or "–" buttons to go to the desired consumable and press "Enter": the last digit of the count will start flashing.
  6. Press "Cancel" to decrease the digit amount or press the "On-line" button to increase the digit amount; press the "+" or "–" buttons to move along individual digits in the count.
  7. Once the count is at the level you desire, press and hold the "On-line", "Cancel", and "Back" buttons simultaneously until the “*” reappears next to the count; consumable’s count has been reseted to the number specified.
  8. Press the "+" or "–" buttons to move to the next consumable and repeat at step 5.
  9. Once all consumable counts have been set to desired amounts that are below their end-of-life thresholds, use the "Back", "+", and "-" buttons to exit through the menus (reverse of steps 2 through 4) until “INITIALIZING” is displayed.
  10. Turn off the printer and turn on.

No comments: