Skip to main content

Posts

Showing posts from July, 2012

Error Code 325 ECM, 326 ECM, 327 ECM, 328 ECM on HP Officejet pro 8500 series

Error Code 325 ECM, 326 ECM, 327 ECM, 328 ECM are Fax errors. Telephone line conditions are very poor. Solution 1 : Try to send the fax at a different time when telephone line conditions have improved.  Solution 2 : Disable ECM (Error Correction Mode).  Errors might still occur, and might result in a degraded image quality on the received page. However, the ability to send the entire document will be improved. 

Open Heat Error on samsung SCX-4521F & SCX-4100 printers

Solution 1 : Open the back cover. There are two wire connector just near ribbon connector: this is thermistor. Verify and fix.  Exploded view on this site: https://www.mk-electronic.de/Teilekatalog

Error P,7 P7 or P07 (5B00) on Canon printers

Solution 1 : If the device is not functioning properly or to clear memory, reset it. On the operator panel, press the button. (The display will go blank.) Note : It may be necessary to unplug the power cord if pressing the ON button does not shut off the printer. Wait approximately ten seconds and then press the button again. Wait until the device has completed its cycling process before submitting another job request. Note : It may be necessary to unplug the power cord and retry if the above steps do not clear the error.   Solution 2 : Step 1: Entering Service Mode While the printer is OFF, press and hold the Start/Stop button (Resume/Cancel in some other models). While holding the Start/Stop button, press and hold the POWER button. When the POWER LED (green light) lit, release the Start/Stop button (still holding the POWER button). Press the Start/Stop button TWICE (still holding the POWER button) Release the POWER button. Wait for the LCD to display “0

Solving error 5B00 on printers Canon Pixma IP6210D and IP6220D

You need to reset waste ink counter: Step 1. Enter Service Mode * Plug in power cable to electric source. * Press and hold RESUME/CANCEL button * Press POWER button * Release RESUME/CANCEL button * Press RESUME/CANCEL button twice in a row Step 2. Reset Waste Ink Counter Operation * Press RESUME/CANCEL button 4 times in a row * Turn of the printer and then turn on again the printer. the Ink counter has been reseted

Solving error P02 on Canon printers

Error P02 or P,0,2. It's a paper jam or carriage error Solution 1: Power off and on the printer Move the carriage from right to left Solution 2: Verify that there is no foreign body inside the printer (scrap of paper, paper clip). Solution 3: Clean the encoder strip ( semi-clear mylar strip located just behind the carriage rod) ; use only a dry lint free cloth. Solution 4 : a part inside the printer is defective Timing Slit Film Carriage units Logic board Carriage motor