Skip to main content

Posts

Showing posts from March, 2011

Minolta 1080 error code list

  C000 Main drive problem C001 Main drive speed. Too fast or too slow C004C Fan motor problem C004E Power supply fan problem C0070 Toner motor drive problem C0071 Toner motor speed. Too fast or too slow C010 Drum motor drive problem C011 Drum motor speed. Too fast or too slow C0400 Exposure lamp does not turn on or AE sensor problem C0500 Low fuser temperature during warm-up C0510 Low fuser temperature after warm-up C0520 High fuser temperature C0600 Scan motor drive problem C0610 Lens motor drive problem C0620 Mirror motor drive problem C0990, C0991 Main tray up problem C0992, C0993 Main tray down problem C0994 Elevator motor problem

How to replace the belt on HP Designjet 5000 series

Remove the left hand cover: Switch off the Printer and remove the power cable. 1. Remove ALL the Ink Cartridges from the Printer. 2. Open the Top Cover. 3. Open the door at the back of the Left Hand Cover. 4. Disconnect the Electrical Cable from the rear of the Ink Cartridge Tube Connector. 5. Disconnect the Air Tube. 6. Twist the 3 latches at the rear of the Ink Cartridge Tube Connector and release the complete Assembly. 7. Remove the Ink Cartridge Tube Connector and place safely on the window. 8. Remove 1 T-15 screw (Type F) from the Left Hand Cover (rear). 9. Close the Left Back door and remove 1 T- 25 screw (Type U) from bottom side (rear) of Left Hand Cover. 10. Remove 3 T-15 screws (Type F) from the Left Hand Cover (front). 11. Remove the Left Hand Cover from the Printer. When handling the Tubes make sure you do not damage them by twisting. Remove the right rear cover: 1. Remove one T-15 screw (Type B) from the Right Rear Cover. 2. Remove the Right Rear

Message Error call service 7980 on Kyocera printers

This error code appears on these printes: FS-1116MFP, FS-1118MFP, FS-1016MFP, FS-118MFP, KM-1815, CS-1820... Cause :   Waste toner tank overflow If the bottle is not full then the sensor thinks it is Solution : Clean the sensor Replace waste toner tank

Installing the Perforation Cutter and the Receipt bac on DFX-9000

Unpack the Receipt bac and the Perforation cutter from the carton box. Take out the protective material from the perforation cutter.   Turn the cover forwards 1. Unscrews the two screws on the left side 2 and right side 3 , which maintains the paper guide 1 2 3 Open the Rear Unit and remove the Paper Guide.   Caution : The perforation cutter is heavy; handle with care and use the handle Install the Perforation Cutter in the specific emplacements in each side 4 & 5 . 4 5 Ensure each shaft of each side is correctly inserted in the housings   Connect the I/F cable in the connector in the left side (from back side). Close the Cover Rear Insert the Supports for the receipt bac into the holes of the perforation cutter on each side. Hang the receipt bac on the support Final configuration