Skip to main content

Posts

Showing posts from October, 2010

Waste ink absorber reset on Canon IP1700

Solution 1: First power off the printer. Next, while holding STOP/RESET button, power on the printer. While holding POWER button, release STOP/RESET button. Then push STOP/RESET button twice. Wait about 20-30 second until the LED shows “0″. Then push STOP/RESET button four times. Finally push POWER button twice. Last step is to turn off the printer by pressing the POWER button one last time. Solution 2: Unplug power and USB cable. Open door and hold power button. Connect power. Close door, then release power button. Solution 3: Turn Off the printer, and then take off the cable power. Push and hold the power button Connect again the power cable. Use your middle finger to push the resume button 2 times. Release the power button.

Replacing carriage belt on HP Designjet 500

Unlock Carriage: The purpose of this Service Utility is to unlock the Carriage Assembly which is normally locked by the Service Station in order to cap the Printheads. Once unlocked, the Carriage Assembly can then be moved freely along the Printer by hand. Perform the Unlock Carriage utility as follows: In the Service Utilities submenu, scroll to "Unlock Carriage" and press Enter. Once the utility starts, the printer will begin to unlock the Carriage Assembly and the following message will be displayed on the front panel. Once the Carriage is unlocked (Printheads have been uncapped) the following message will appear on the front panel: NOTE The Carriage will remain uncapped until another action (e.g. loading paper or replacing Printheads) is selected which returns the Printer to normal operation. Make sure you leave the Carriage in a locked position once the repair is completed. Removal 1. Switch off the Printer after unlocking carriage. 2. Remove the Left Hand Cover