Skip to main content

Posts

Showing posts from August, 2009

Some errors codes on Xerox Phaser 8400

8,009.4x :CAP_FAULT_MP_NO_ CLUTCH_STALL: The media path motor has stalled while moving without the clutch engaged. 33,001.4x - TM_DEV_FAULT_MPT_WIDTH_VALUE_TOO_LOW Tray 1 status: 1. Check the wiring and connectors from the front door to the I/O board. 2. Run the Test Tray 1 Width Sensors. 3. If the test fails replace the front door. 4. Replace the I/O board. 08.055.44 : The media path drive module has stalled while engaging the head tilt. 37,008.44 : The Preheat preheater is not drawing the expected power from the supply. Run the Preheat Heater test, check the wiring. If test fails and no apparently problem is evident, replace the preheater. 05,002.42 : Problems with the Y-axis. It could be the belt,motor or the drum. 7,008.4x : PM_FAULT_HEADTILT_NOT_ ENGAGED The printhead tilt is not engaged, so it didn't tilt back properly or the printhead is stuck in the tilted position by the tilt lock arms. The process motor gear train getting out of sync can

Canon i350 waste tank full: how to reset

Solution: Download the I320 Service Tool (.exe), run the i320 service tool and follow the steps below: Install the print head, and while holding down the POWER button, plug in the AC cable (the green lamp lights up.) While still holding down the POWER button, press the RESUME button twice and release the POWER button to enter the Service Mode (each press of the RESUME button changes the LED color: the LED lights in orange the first time, and in green at the second time.) Connect the printer to the computer, select "USB PORT" using the i320 service tool. Destination setting: other than Japan: select "1" in "SET DESTINATION", Japan: select "2" in "SET DESTINATION". EEPROM is reset at the same time when the destination is set.

Error 0xf0af8005 on HP printers

Printers HP: 4212 / 4215 / 4255. Solution 1: That error indicates a power supply problem internally in the unit. You will need to call HP to obtain the replacement part or get it replaced free under warranty. Solution 2 : You can reset the product, if you are lucky it will works: Without turning off the product, disconnect the USB cable from the rear of the product. Remove the cartridges from the product. Wait for the ' Insert Cartridges ' message to display on the control panel. Disconnect the power cord from the back of the product. Wait 60 seconds. Reconnect the power cord. If the product does not automatically turn on, press the Power button. Reinsert the cartridges, and then close any open doors on the product. If you receive a prompt to print a calibration page, do so. Reconnect the USB cable to the rear of the product, and then try printing again.

Hard Reset procedure for HP C6180

Procedure: Remove all cables, including: Unplug the printer power. Hold down # and 6 on the keyboard. Plug the power cord back in.

Error code E000733-0001 on Canon IR2200

E733-0001 means a fault is detected by the main controller PCB in the communication between the DC controller PCB and the main controller PCB. Main cause: The connector has poor connection. The DC controller PCB is faulty. Solution : Verify the connection between the connector J1015 on the main controller PCB and the conductor J316 on the DC controlled PCB is normal. Correct the connection if necessary. The connection is correct: Replace the DC controller PCB .